#Opcom ftdi update tool software
Never had this kind of tool in my hand Similar is happened with the chinese opcom v6 hardware If you are using it with opcom china clone 2010 all its ok but if you change the software and you are using it with vauxcom 120309a the tool is not working on k-line. If you have no experience, go to buy a working Opcom v6 (it’s cheap- 20 euro around) This is Opcom v6 board No need rework Source: O pcom clone working with k-line? If I do not make a mistake that tool is made in Russia That tool it has a different design then a china clone ( that its 1:1 with opcom rev b genuine obe but with a different pcb design ) So in this case this tool is using a different firmware, a small moded one for that schematic. Real measuring on PCB V5 is: PIN4 is Rx -–> PIN19 Tx Pin1 is Tx -–> PIN23 Tx PCB rework requires technique and experience. Whole protection is in FTDI CHIP ID.įTDI PID is possible change. The differences are only in firmware FW 1.60 and FTDI PID. Kline OK HSCAN OK MSCAN OK SWCAN OK All works ok I have Bulgarian OPCOM HQ version 131223c EN. I managed to update Op-com v5 to Op-com V6, see how i rework: Opcom v5 PCB: Rework to Op-com V6: I an instruction for all. The FTDI firmware section includes firmware development tools and resources for the FT9xx 32-bit Microcontroller Series, and for the Vinculum Series.
0 kommentar(er)
